This product is in high demand, and we just sold out. You can order online to reserve your unit or Angebot anfordern
Normaler Preis$2,471.00Angebot
The Beam Analyzer is an award-winning device that allows you to measure the beam specifications of laser light show projectors up to 100W with incredible accuracy. The Beam Analyzer is essentially a “lie detector” that helps you determine if your laser’s beam specifications are correct or not.
The Beam Analyzer allows you to measure in real time:
Beam Divergence
Beam Alignment (X*Y mrad)
Power Output
Lens collimating of laser sources
To operate the Beam Analyzer, you will need to use the software that is included for free. The software enables you to preform all the measurements and see the data from the Beam Analyzer. You can download that here
Product Overview
This device analyzes a laser beam to enable to measure the main specifications that qualify the quality of the beam. The angular measurement method used by the beam analyzer gives the advantage to not depend on the input beam diameter or on the distance between the measuring device and the laser source. The resolution on the measure is 0.01mrad. You can also add any other wavelength for power and alignment (just requires you calibrate this beforehand).
The Beam Analyzer is well suited for the measurement of the following applications:
Divergence of the laser beam for each color and for all colors simultaneously.
Laser power measurement
Lens collimating of laser sources : minimal divergence
Alignment of RGB laser beams
Optical specifications
Parameter
Symbol
Min
Typ
Max
Unit
Optical power (*)(**)
Popt
0.1
-
100
W
Power measurement accuracy
-
1
-
%
Resolution on divergence
RΦ
-
0.01
-
mrad
Divergence measured (FWHM)
Φ
0.1
-
10
mrad
Input beam diameter
D
-
-
22
mm
Wavelength detected
λ
400
-
1000
nm
Mechanical specifications
Parameter
Symbol
Value
Unit
Length x Width x Height (without the support / handle)
L x W x H
100 x 75 x 57
mm
Weight
msys
500
g
Electrical specifications
Parameter
Symbol
Value
Unit
Typical consumption (USB 3.0)
PUSB
2
W
(*) The sensor of the LBA-C must remain below 75°C while operating. It may be need to dissipate heat from the case with a fan when using the device with high power beams for a long period.
(**) A correct alignment should be done before setting the laser projector to maximum power. The user must follow the alignment procedure described in the User Manual to prevent damage to the system.
